Heating System Efficiency

Whether you need installation, service or repair, we have your heating system covered.

Tank Installation

We can supply & install new or replacement domestic oil tanks. Arrange a site inspection and see if we can assist.

System Flushing

Clear out debris and dirt that has built up in the system over time helping with heating efficiency.

Smart Controls

Help manage your energy usage. We can supply & install Hive or Nest controls.

Boiler Efficiency

Our engineer when servicing  your boiler can discuss with you  how best to maximise your boiler efficiency.

Call today to arrange a service or ask about how we can help you.

Hints and Tips

Why does my heating stay on when the clock/programmer is off?

This is usually the result of a faulty actuator on a motorised valve.

Why are my radiators cold when my boiler is hot?

This is normally a result of the circulation pump or a motorised valve having failed.

Why is my radiator cold at the top but warm at the bottom?

This is usually caused by air being trapped in your radiator. Using a suitable radiator ‘airing key’, you should be able to release the trapped air through the ‘bleed point’ at the top of your radiator.

Where do I find my oil shut off valve?

Your main oil shut off valve can usually be found at the bottom outlet of your fuel tank. The valve will have either a wheel type handle (clockwise to close) or a lever handle (quarter push to close).

Do I need to service my boiler and if so how often?

Annual servicing can increase your boiler efficiency, reduce emissions and ensure its safe operation. Studies have found that with just a 3mm layer of soot, your boiler efficiency can be reduced by more than 8%.

Where do I find my boiler restart button?

Your boiler restart button, also referred to as ‘lock out’, is located on your boiler burner unit. Usually, the burner unit front door cover will need to be removed to gain access to the control box reset (when ‘tripped’ the button is normally illuminated). To initiate a start-up, simply push the reset button – always […]

Why does my boiler gauge show no pressure?

The majority of modern boilers are installed as sealed systems with no header tank to automatically top up the system with water. The system pressure gauge, located either on the front of the boiler or on a nearby pressure vessel, will normally indicate 1 Bar when the system is cold. If your gauge is showing […]

Fault: Oil Boiler Locking Out

Have you checked your Fuel level? If there is plenty of oil in tank – call us and we can arrange someone to callout. If oil level is low or tank has ran dry the boiler will Lockout. Buy Heating Oil.